1.Use the Sender(Switch to "Cont")Connect the test leads to the object pair,use "Cont"postion.The bright green of "Cont" indicates the continuity.(line resistance not exceeding 10K?.)
2.Use the Sender(Switch to "Cont")
a.Connect the test leads to pair of cables,touch Receiver to the cables.if the two cables give larger and same tones,it means both of them have continuity.Otherwise the cable which gives lower tone does not have continuity.
b.Connect one test lead to one cable among a group of cables,connect another test lead and the other cables to earth ground.Touch the tip of Receiver to another end of the cable mentioned above.Reception of tone means that the cable has continuity.
Use Sender(Switch to"OFF")
Connect the red test lead to the side of one line and the black test lead to the side of another line.
a."Cont"indicator light is "green"when you connect the red test lead to the Ring (-)side.
b."Cont"indicator lighe is "red"when you connect the red test lead to the TIP(+)side.
2.Identify CLEAR,RINGING,BUSY state on the working telephone line:connect the red test lead to the RING side,black test lead to the TIP side,or connect RJ11 into the RJ11 socket on telephone.
a."Cont"indicator light is "green",indicates a CLEAR line,if "CONT"indicator light is "red",it means the polarities were reversed.
b."Cont"indicator does not glow or glow faintly,indicates a BUSY line.
c."Cont"indicator light brightly flickering"YELLOW",indicates a RINGING line.(Switch to"CONT"will terminate the call one line).
1 x Optimal Shop Cable Emitter.1 x Optimal Shop Cable Receiver.1 x toolkit.1 x user manual
1.This cable tracker is designed to identify and trace wires or cables within a group without damaging the insulation. For telephone line, it can identify some states in the line. Owning this instrument, it is more convenient to install, debug, and maintain telephone line. There are a sender and a receiver included in the cable tracker.
2.Functions?1.Judge continuity of the cables or wires?2.Track the cables or wires, and diagnose the break point?3.Receive the tone signal on the cables or wires (telephone line)?4.Identify the state in the working telephone line (clear, ring, busy)?5.Send a single solid tone or dual alternating tone to the object cables or wires?
Note:1.if you do not use the cable tracker.set the switches to "OFF".if you do not use the cable tracker for a long time,take out all the batteries.2.keep away from moistute.3.Do not use Cable Tracker under high voltage environment.4.Always follow this users manual.Otherwise it may cause the damage to the tester or personal injury.