1. Insert one end (RJ45 / USB) into the transmitter port (TX) and the other end into the RJ45/ USB port of the mobile terminal box or the receiving port (RX);
2. The LED on mobile terminal box and main body will show the the contact situation of the measured line at the same time;
Mobile Terminal Box Usage:
1. Insert one end of the test lead into the firing hole (TX) of the tester body and the other end into the connector of the receiving mobile terminal box. Turn on the power switch to AUTO mode (AUTO). If the test is on the panel or on the patch panel, use the auxiliary line to connect.
2. Open the power switch to "TEST" section, is a step by step test. LED lights will be in the side of the first line of the connection point, each press a test button, LED lights will be lit in the next connection point to be tested, followed by down, and again and again. Power switch to "AUTO" section is the automatic scanning mode, LED lights will automatically from the first point to the eighth point and the ground point,Package Included:
1 x Telephone USB A B Cable Tester
1 x User Manual