" Note: This PoE injector only used for 10/100Mbps network. it compatible with 48V-54V power device.
The iCreatin PoE Injector can save you money by using an existing Ethernet line to deliver data and power.
The iCreatin PoE Injector can easily connect any IEEE 802.3af-compliant device to a non-PoE LAN switch port.
This PoE Injector can be used to connect a wireless access point, IP phone, network camera, or any IEEE 802.3af powered device to a LAN switch.
Reduce Wiring Costs With the iCreatin PoE Injector you can dramatically reduce wiring costs by powering devices through your existing Ethernet line rather than running new AC power lines.
To use this PoE injector, all you need to do is connect the iCreatin PoE Injector to the LAN switch port, and then use your existing Ethernet Cable to deliver DC power and data to your device.
Protect Your Equipment Now that you are running DC power to your networked equipment through the Cat5 cabling, you need to be sure that your devices are protected from power problems.
The iCreatin PoE Injector is designed with short circuit protection Over Current and Over Voltage Protection, keeping your devices safe. It is also protect your products from overloads over 500mA and high voltages exceeding 56Vdc.
2 RJ45 Ethernet ports
54V (48-56V) 0.5A 24W power output,
Power feed: V+ 4,5; V- 7,8; Data: 1,2, 3,6
Data rate: 10\100Mbps
Deliver power up to about 328.1 feet(100 meters)
Support 100-240VAC voltage input
What in Box?
1 x US wall Plug PoE injector;
Remotely power PoE Device Thru CAT.5,6,7 Cable up to 328.1 feet(100 meters)
IEEE802.3af Power over Ethernet with 48-54V Power Supply, US wall plug type.
Input 100-240VDC, Output: 54V (48-56V) 0.5A 24W passive PoE Output
Short Circuit, Over Current and Over Voltage Protection
Compatible with most 10/100Mbps IP camera, IP phone, Wireless IP point and other PoE devices.